+8615280858852
+8615280858852
1.Installed abrasive paper (before installation, please put gloves, the fingers were not galled by sand) Get abrasive paper that length is 473 +-1mm and width is 400 mm at least. But those two items do not exceed roller, the average thickness is about 1.0 0.2 mm. Get three bars double-face tape that is equal to roller, the thickness is 0.2mm at most, the width is 50mm, add them on roller well-di...
1. Sample Preparing Every sample should be put in the environment with temperature 20~250℃ and humidity 20~70% for more than 4 hours. 2. Testing Procedure 2.1. Keep the sample shape and static without moving. 2.2. Remove the test part from the entire toy in order the Toy Safety Sharp Edge Tester can touch it, but must keep the original rigidity. 2.3. The beginning and end of the PTFE tape can be c...
Make sure that the safety catch is locked. Loosen the blade retaining screws to allow the blade retaining plates to be removed, then either turn or replace the blades. Replace the blade retaining plates and tighten the screws. Repeat this procedure for each blade. Note that blades may be rotated until all cutting corners have been used. AVENO Machine Recommend AG26 100CM2 Sample Cutter Contact Us ...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch it. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure to the handle and...
1. Wash fastness tester instrument leaking ▲Check if the drain connector or drain valve is secure ▲Whether it is the connection of the heating pipe joint, the water level gauge, the rotating shaft, it is tightened or the gasket needs to be replaced. ▲Excessive water levels can also cause water leaks. 2.After installation, power on the work interface and click “Rotate”. The mot...
What is Electronic Twist Tester? Electronic Twist Tester is special equipment used to measure the yarn twist, degree of inhomogeneity of yarns in certain lengths of cotton, wool, linen, and silk, and the twisting and shrinkage of strands, as a basis for assessing product quality and improving the production process. The test method of Electronic Twist Tester? Average untwisting slip elongation Ave...
online service
+8615280858852
sales@avenotester.com
sales@avenotester.com
+8615280858852
