+8615280858852
+8615280858852
1. The sample is parked in the laboratory environment for more than 8 hours. 2. Cut a piece of specimen on the flat part of the sample. If it is an insole, it should be cut to the transfer site. Samples should be representative. 3. Remove the load and load shaft from the Martindale Abrasion and Pilling Tester. 4. Remove the top plate and test fixture. 5. Installation of sample: loosen the fixing r...
1.The Martindale Abrasion Tester need to clean on a regular basis to ensure cleanliness. 2.Regularly check if the Abrasion and Pilling Tester abnormal. 3.Please use the Martindale Test Machine according to the instructions, so as not to damage the instrument and affect the life of the instrument. 4.Please put the accessories back to their original position after use to avoid loss. 5.Turn off the p...
ICI Pilling and Snagging Tester is used to determine the surface fuzzes and pilling properties of both woven and knitted materials. It complies in full with the requirements of EN ISO 12945-1 and BS 5811, etc.. Below is the attention items: Maintenance tips: Regularly check the control panel keys and the screws on each part normal. Regularly clean the cork liner with suitable cleaning solvent, suc...
1.Before test, clean the ICI Pilling Box with a vacuum cleaner or brush, make sure do not leave any fibers. 2.Placed equipped sample in the ICI Pilling Box. 3.Close the lid of the ICI Pilling tester for Fabric pilling box and fix it. 4.Set the number of revolutions of the ICI Pilling and Snagging Tester. 5.After test, take our the sample and remove the suture. AVENO Machine Recommend: ...
Open Martindale Abrasion and Pilling Tester’s power switch, the screen will show following: Press the test to enter the work interface, the screen will show following: (1) When the Martindale Abrasion Tester is not in working state, Click “Times” button to set test times. The setting range is 0~999999 times. (2) When the Martindale Abrasion Tester is not in working state, Click “Speed” button to s...
1. Do not install the Desktop Light Fastness Test Chamber unit near other heavy machinery. 2. Avoid unnecessary pausing during running of test as repeated switching off/on of unit will reduce the lifetime of the Desktop Light Fastness Tester's Xenon lamp. 3. Use “RST” key to stop machine mid-test. Do not switch off unit directly as this will reduce the lifetime of the Xenon lamp. AVENO...
online service
+8615280858852
sales@avenotester.com
sales@avenotester.com
+8615280858852
