+8615280858852
+8615280858852
Manual Laboratory Padder is used to test the liquid content of fabric when textile printing and dyeing, finishing process, and holding uniform rolling surplus rate to make water content stable. Also can used to pull out moisture of the soaked textile, it is a very convenient, simple and effective laboratory test tool. Do you want to know more about the Laboratory Dyeing Padder? Control mode: Manua...
1. Before using the 5KN 10KN 20KN strength tester, check whether there is a reliable grounding device. 2. The voltage in the laboratory must be stable. It is best to install a voltage stabilizer in the laboratory. Do not use the Universal Testing Machine (Dual Column) when the voltage is unstable, so as to avoid short-circuiting and burning circuit boards due to unstable voltage. 3. When replacing...
Manual Fabric Stiffness Tester is suitable for rigid flexibility test of cotton, wool, silk, hemp, chemical fiber and other woven fabrics, knitted fabrics and general nonwovens, coated fabrics, and other flexible materials, such as paper, leather, film and other flexible materials. Do you want to know more about the ASTM D1388 Stiffness Tester? Test angle 41.5° Press block length 200mm Press block...
Prepare the sample of Crumple Flex Tester 1. As far as possible, place the sample in an environment with a temperature of (23±2)℃ for at least 3 hours. 2. Take out the controlled test sample, use a knife mold (220*190mm) to plant at least 4 test pieces from the effective width fabric, and pay attention to taking the average number of test samples in the radial and transverse directions when sampli...
1. Prepare the test piece of Manual Fabric Stiffness Tester: 1) Use scissors to cut out the size of 25mm×200mm from the sample to be tested, with the long side of the sample facing the warp direction, the weft direction, and three samples each without damage and defects. If possible, samples in all directions should not contain the same number of warp (weft) yarns. 2) Specimen processing: All spec...
1. Correction shoes Inserts Flexing Tester items: folding distance and speed. 2. Calibration equipment: height gauge, infrared speed measuring device 3. Calibration cycle: one year 4. Correction steps: a) Verification of endurance distance i. First manually adjust the clamp to the lowest point, use a height ruler to measure the height of the rubber interlayer of the two fixed rods (middle), and re...
Colorfastness Rubbing (Gakushin) Tester is Rubbing color fastness tester for JIS standard method, apply to test the decolorization performance of fabric after friction under dry / wet state. Do you want to know more about the Gakushin Tester? Test position: 6position Friction hammer surface radius: R45mm Friction hammer track: 100±1 Friction hammer load: 2N(200g) Test speed: 30±2r/min Sample stage...
1. Use the fiber cutter provided by Aveno company to cut a proper amount of fiber to be tested. 2. Prepare clean glass slides and coverslips required for Fiber Content Analyzer testing. 3. Drop an appropriate amount of glycerin or paraffin oil on the glass slide. 4. Put the cut fibers on the glass slide and stir evenly to spread the fibers evenly. 5. Cover the cover glass and drive out the bubbles...
Electronic Tearing Tester is used for testing the tearing strength of all kinds of fabrics (Elmendorf Method), and the tearing resistance of thick paper, plastic cloth, electrical tape, etc. Do you want to know more about the Paper Tearing Tester? Included Standard Accessories 32N load weight 1pc 64N load weight 1pc Sample Template 1pc English operation software 1pc Cable connect to PC 1pc Sp...
online service
+8615280858852
sales@avenotester.com
sales@avenotester.com
+8615280858852
