+8615280858852
+8615280858852
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch 100CM² Sample Cutter. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure...
Make sure that the safety catch is locked. Loosen the blade retaining screws to allow the blade retaining plates to be removed, then either turn or replace the blades. Replace the blade retaining plates and tighten the screws. Repeat this procedure for each blade. Note that blades may be rotated until all cutting corners have been used. AVENO Machine Recommend AG26 100CM2 Sample Cutter Contact Us ...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch it. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure to the handle and...
Sample Prepare Laboratory Sample - As a laboratory sample, randomly select a quantity of buttons, approximately 100 to 200, from a carton and from contained boxes, that adequately represents the material, from which test specimens may be selected. Test Specimens - Randomly select 15 buttons from the laboratory sample for testing. If test specimens are submitted for preproduction approval, testing ...
1. Prepare the test piece of Manual Fabric Stiffness Tester: 1) Use scissors to cut out the size of 25mm×200mm from the sample to be tested, with the long side of the sample facing the warp direction, the weft direction, and three samples each without damage and defects. If possible, samples in all directions should not contain the same number of warp (weft) yarns. 2) Specimen processing: All spec...
Manual Fabric Stiffness Tester is suitable for rigid flexibility test of cotton, wool, silk, hemp, chemical fiber and other woven fabrics, knitted fabrics and general nonwovens, coated fabrics, and other flexible materials, such as paper, leather, film and other flexible materials. Do you want to know more about the ASTM D1388 Stiffness Tester? Test angle 41.5° Press block length 200mm Press block...
online service
+8615280858852
sales@avenotester.com
sales@avenotester.com
+8615280858852
