+8615280858852
+8615280858852
Please add the lube to the belt pulley axletree and rotating member to make it working well. Please clean the Fabric Pilling Tester face everyday after your test, and you should spray the rust preventing oil regularly. Please check the tightness of the Random Pilling Tester’s belt regularly, and adjust or change the new belt of same standard depending on the circumstance. AVENO Machine R...
1. Before using Low Temperature ROSS Flexing Tester, first check if there is a reliable grounding device. 2. The laboratory voltage must be stable, it is best to install a voltage regulator in the laboratory, when the voltage is unstable, do not use the test equipment, so as to avoid the phenomenon of short circuit burning circuit board due to voltage instability. 3. When replacing the test piece,...
Place the sample on the cutting board making sure that it is flat and smooth, do not stretch 100CM² Sample Cutter. Place the cutter on the sample and release the safety catch, this is done by withdrawing the head of the catch, turning it through 90 degrees and locating the pin in the two recesses, this allows the blades to become operational. Whilst holding the cutter with one hand, apply pressure...
1.Installed abrasive paper (before installation, please put gloves, the fingers were not galled by sand) Get abrasive paper that length is 473 +-1mm and width is 400 mm at least. But those two items do not exceed roller, the average thickness is about 1.0 0.2 mm. Get three bars double-face tape that is equal to roller, the thickness is 0.2mm at most, the width is 50mm, add them on roller well-di...
1. Sample Preparing Every sample should be put in the environment with temperature 20~250℃ and humidity 20~70% for more than 4 hours. 2. Testing Procedure 2.1. Keep the sample shape and static without moving. 2.2. Remove the test part from the entire toy in order the Toy Safety Sharp Edge Tester can touch it, but must keep the original rigidity. 2.3. The beginning and end of the PTFE tape can be c...
1. Wash fastness tester instrument leaking ▲Check if the drain connector or drain valve is secure ▲Whether it is the connection of the heating pipe joint, the water level gauge, the rotating shaft, it is tightened or the gasket needs to be replaced. ▲Excessive water levels can also cause water leaks. 2.After installation, power on the work interface and click “Rotate”. The mot...
online service
+8615280858852
sales@avenotester.com
sales@avenotester.com
+8615280858852
